Toms River Drywall. (732) 844-8239

Drywall Installation for Toms River, NJ Homes

Request a quote

Send the room and the problem. We reply during working hours.

Or call (732) 844-8239. Mon–Sat 7:00am–6:00pm.

Toms River Drywall installs gypsum board in Toms River and the surrounding Ocean County shore towns, taking remodels, conversions, and newly framed rooms from bare studs to a paint-ready surface.

Drywall job photo

Sheet layout before the first screw

We run board across the framing so every seam lands on solid backing, and we keep butt joints away from window and door corners where a shore house moves the most. Ceilings get hung before walls so the wall board carries the ceiling edge, and on framing spaced 24 inches on center we use 5/8" panels, because 1/2" board on wide spacing is the sag you notice two summers later.

Picking the right panel for a coastal house

A block from the water, board choice is not academic. Bathrooms, laundry areas, and any wall that backs plumbing get moisture-resistant panels. The wall between an attached garage and the living space gets at least 1/2" gypsum board on the garage side, and where habitable rooms sit above the garage, New Jersey requires a one-hour fire-resistance-rated separation, commonly built with 5/8" Type X board. Everything else is standard 1/2", and we verify the assembly on site rather than assume the plan covered it.

When a permit applies

New Jersey treats replacing interior finishes on less than 25 percent of the wall area of a one- or two-family home as ordinary maintenance, with no permit (N.J.A.C. 5:23-2.7). Rehanging most of a floor, a basement from bare studs, or work tied to structure or fire safety goes through your town's construction office first.

Cottage-to-year-round conversions

Seasonal houses being winterized get insulation-coordinated hangs and vapor-aware detailing.

Whole-room remodels

Demo checked for square and crown before board goes up, then tape, coat, and sand.

Ceiling replacements

Failed or stained lids swapped without opening the walls below them.

  • Seams planned to land on solid framing
  • Level 4 default, Level 5 where light demands it
  • Moisture-resistant board specified room by room
  • Job site broom-clean and debris gone at the end