Water Damaged Drywall Repair in Toms River, NJ
Toms River Drywall rebuilds water-damaged walls and ceilings in Toms River, where Superstorm Sandy flooded low-lying neighborhoods in October 2012 and burst pipes and roof leaks cause the same damage on a smaller scale.
The meter decides where the cut goes
Gypsum pulls water upward far past the line you can see, so cutting at the stain is cutting too short. We probe with a moisture meter, open the wall to where the readings go dry, and pull soaked insulation out of the bays. If the studs still read wet, the rebuild waits, because sealing damp framing behind new board is how a water problem becomes a mold problem.
Rebuilding on flood-prone streets
On lagoon-front and low-lying blocks we rebuild with the next event in mind: moisture-resistant board on the lower wall, panels held off the slab so a shallow intrusion cannot wick upward, and horizontal seams placed where a future flood cut would land cleanly. Insulation goes back to match what came out, and the wall closes only once the framing reads dry.
Flood-line cuts
The lower portion of the wall removed at a clean, uniform height and rebuilt.
Ceilings under leaks
Opened, dried, and closed only after the roofer or plumber has fixed the source.
Frozen-pipe damage in seasonal homes
Every bay along a burst line opened and checked, not just the one with the visible stain.
- Framing metered dry before new board goes in
- Board held clear of slabs on flood-prone streets
- Soaked insulation pulled from every wet bay
- Walls closed only after the leak source is fixed
Towns we work in
Serving Toms River and towns roughly 25 miles out.